The is a monolithic quint differential line receiver with emitter-follower outputs. An internal reference supply (VBB) is available for single-ended reception. When used in single-ended operation the apparent input threshold of the true inputs 30 mV higher (positive) than the threshold of the complementary inputs. Unlike other F100K ECL devices, the inputs do not have input pull-down resistors. Active current sources provide common-mode rejection 1.0V in either the positive or negative direction. A defined output state exists if both inverting and non-inverting inputs are at the same potential between VEE and VCC. The defined state is logic HIGH on the Oa�Oe outputs.Features
35% power reduction of the 100114 2000V ESD protection Pin/function compatible with 100114 Voltage compensated operating range to -5.7V Standard Microcircuit Drawing (SMD) 5962-9162901Description Inverting Data Inputs Data Outputs Complementary Data Outputs
If Military/Aerospace specified devices are required, please contact the National Semiconductor Sales Office/ Distributors for availability and specifications. Above which the useful life may be impaired (Note to +150�C Storage Temperature (TSTG) Maximum Junction Temperture (TJ) Ceramic to +0.5V Pin Potential to Ground Pin (VEE) Input Voltage (DC) VEE to +0.5V Output Current (DC Output HIGH) -50 mACase Temperature (TC) Military Supply Voltage (VEE) to -4.2V
Note 1: Absolute maximum ratings are those values beyond which the device may be damaged or have its useful life impaired. Functional operation under these conditions is not implied. Note 2: ESD testing conforms to MIL-STD-883, Method 3015.
Symbol VOH Parameter Output HIGH Voltage Min -1025 Typ Max -870 Units +125�C -1085 VOL Output LOW Voltage -1830 VOHC Output HIGH Voltage -1085 VOLC Output LOW Voltage -1555 VBB Output Reference Voltage -1380 -1396 VDIFF VCM VIH VIL IIH Input Voltage Differential Common Mode Voltage Single-Ended Input High Voltage Single-Ended Input Low Voltage Input HIGH Current 50 70 ICBO IEE Input Leakage Current Power Supply Current -870 mV VCC - 2.0 VCC to +125�C VIN = VEE, Da�De = VBB, Da�De = VIL Da�De = VIL
(Notes 4, 5) IVBB = -350 �A, VEE = -5.7V Required for Full Output Swing (Notes 4, 5) (Notes 4, 5) Guaranteed HIGH Signal for All Inputs (with Dn tied to VBB) Guaranteed LOW Signal for All Inputs (with Dn tied to VBB) VIN = VIH
Note F100K 300 Series cold temperature testing is performed by temperature soaking (to guarantee junction temperature equals -55�C), then testing immediately without allowing for the junction temperature to stabilize due to heat dissipation after power-up. This provides "cold start" specs which can be considered a worst case condition at cold temperatures. Note 4: Screen tested 100% on each device -55�C, +25�C, and +125�C, Subgroups and 8. Note 5: Sample tested (Method 5005, Table I) on each manufactured lot -55�C, +25�C, and +125�C, Subgroups 3, 7, and 8. Note 6: Guaranteed by applying specified input condition and testing VOH/VOL.